From d93d27afa45567b97d1a4f8c00753c83f6eee5c4 Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?Marcus=20Thelander=20Andr=C3=A9n?= <marcus.thelander_andren@control.lth.se> Date: Wed, 10 Apr 2019 18:16:59 +0200 Subject: [PATCH] Update installation.md --- docs/src/man/installation.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/docs/src/man/installation.md b/docs/src/man/installation.md index ef4248b..fa8216a 100644 --- a/docs/src/man/installation.md +++ b/docs/src/man/installation.md @@ -18,8 +18,8 @@ Make sure that the Julia folder has the correct name by typing The file structure on the micro-SD now has the correct structure. The final step is to make sure that the micro-SD will automatically flash the Debian image onto the BeagleBone when booting up. To do this, follow the instructions found [here](https://elinux.org/Beagleboard:BeagleBoneBlack_Debian#Flashing_eMMC). Congratulations, you now have a prepared micro-SD card ready for flashing BeagleBones. -## Flashing a BeagleBone from a prepared micro-SD card -Insert the micro-SD card in the slot on the BeagleBone, and press down the boot button S2 (the button closest to the micro-SD slot) and hold it down while you plug +## Flashing the BeagleBone +Insert a prepared micro-SD card in the slot on the BeagleBone, and press down the boot button S2 (the button closest to the micro-SD slot) and hold it down while you plug in the USB-cable to the BeagleBone. Keep the S2 button held down for a couple of seconds, until the onboard LEDs start to blink. After a short while the onboard LEDs should start to flash in a wave pattern, indicating that the BeagleBone is being flashed. After a while (can vary between 5-45 minutes) the BeagleBone will be turn off automatically, indicating that the flashing is complete. Remove the micro-SD before powering on the BeagleBone again (otherwise it will start to flash the BeagleBone again). -- GitLab